Safety note

In an emergency: call local emergency services immediately. If in the water, attract attention by waving an arm. This page gives general information only. Always swim at a patrolled beach and follow official lifeguard advice.

What is a rip current?

A rip current is a localised channel of water flowing quickly seaward through the surf zone. When waves break, water piles up near shore and needs to return to sea — rip currents are the pathways it takes, often flowing through gaps in sandbars or along jetties. They can flow at speeds up to 2.5 metres per second (faster than an Olympic swimmer) over short distances. [1]

How to spot a rip

  • A gap in the breaking waves where water appears calmer
  • Discoloured, foamy or churned water moving seaward
  • Debris, foam or seaweed moving away from shore
  • Often at the edge of a sandbar, near a jetty, pier or headland

Ironically, rip currents often look calmer than surrounding surf — which is why they are deceptive entry points for swimmers. [2]

What to do if caught in a rip

Official guidance from RNLI, USLA and Surf Life Saving Australia (all sources cited below): [3][4]

  1. Stay calm. Rip currents don't pull you underwater — they carry you away from shore. Most people caught in rips are not in immediate danger if they stay calm.
  2. Don't fight it. Swimming directly against a rip exhausts swimmers quickly. The rip is usually narrow — you can escape it without fighting it.
  3. Signal for help by raising one arm and waving to alert lifeguards and others on the beach.
  4. Swim parallel to the shore (along the beach) to escape the rip channel. Once out of the channel, swim back to shore at an angle away from the rip.
  5. If you cannot escape, float and conserve energy until the rip weakens or help arrives. Rips often slow and dissipate beyond the surf zone.
Context: Official advice can vary slightly by country and local conditions. Always follow the instructions of on-duty lifeguards at the beach you are using — they will know the specific hazards of that beach.

Prevention

  • Swim at patrolled beaches, between the flags
  • Ask lifeguards about rip hazards when you arrive
  • Supervise children at all times in the water
  • Never swim alone
  • If in doubt, don't go out

Frequently asked questions

How do you escape a rip current?

The official advice from most lifesaving organisations: don't panic, don't fight the current by swimming directly back to shore. If you can, swim parallel to the shore until you are out of the rip, then swim back to shore at an angle. If you cannot escape, stay calm, float and signal for help. See: RNLI, USLA, Surf Life Saving Australia guidance linked below.

How do you spot a rip current?

Signs include: a gap in breaking waves, discoloured (often darker or churned) water, foamy or choppy water moving seaward, or debris moving out to sea. Rip currents often look calmer than the surrounding surf, which misleads swimmers into thinking it is a safe entry point.

Sources

  1. [1] Brander, R. W. et al. (2013). "The science of rip currents." Coastal Management, 41(1). Used for: rip current speed and mechanism.
  2. [2] Surf Life Saving Australia (2023). "Rip currents." lifesaving.com.au. Used for: identification guidance.
  3. [3] RNLI (2023). "How to escape a rip current." rnli.org. Primary safety guidance used for escape steps.
  4. [4] United States Lifesaving Association (2023). "Rip Currents." usla.org. Used for: US guidance on response.